|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|
Thread Tools | Display Modes |
24-07-2009, 04:23 PM | #1 | ||
Starter Motor
Join Date: Mar 2009
Location: Sydney
Posts: 3
|
I own a Mark 1 Escort. This vehicle was originally fitted with a 1300cc engine but now has a 2000cc Escort engine. The brakes have been upgraded to suite this new engine. We have fitted an RS2000 master cylinder Capri 9.6" front discs and 1600 twin cam 9" rear drums. The original booster is fitted to the vehicle. The brake shoes and pads are all new and the brakes have been bled. The car stops very well, however the problem is that the brake pedal must be pushed down to about 50mm off the floor before the brakes lock up.
Can anyone suggest what I should be looking for or how to fix this problem? |
||
25-07-2009, 04:43 PM | #2 | ||
Regular Member
Join Date: Jun 2009
Posts: 51
|
I had the same problem with mine. Reblead the rears again and pump through a whole container or 1 litre this may fix the sponge. Also have you adjusted the rear drum brakes so they sit tight in the drum
|
||
02-08-2009, 07:37 PM | #3 | ||
Starter Motor
Join Date: Jul 2009
Posts: 12
|
Greetings,
If the problem persists, after the brake system has been effectively bled and the rear brake shoes are correctly adjusted, then you may have fitted a master cylinder with too small a bore size. Did you carry out hydraulic computations before the selection of components? Drop me a line if you need any help. Regards Wayne |
||
Thread Tools | |
Display Modes | |
|