|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
20-07-2013, 02:01 PM
|
#1 | ||
|
Starter Motor
Join Date: Dec 2006
Posts: 11
|
Hi, this morning when I was replacing my Fiesta's headlight bulb I found that it's washer bottle cap has gone missing (foto attached). I have no idea when that happened. Is it known to be something that can just fall off? Is it safe to just leave it without cap.
|
||
|
|
|
22-07-2013, 05:25 PM
|
#2 | ||
|
FF.Com.Au Hardcore
Join Date: May 2008
Location: Darwin
Posts: 1,694
|
Mine was missing too.
I ended up getting some a zip lock bag, pulling it tight over the top, using a rubber band to secure, and then putting a little cut into the bag to allow it to breathe slightly if needed (like when the washers are used). Haven't had any problems doing that. I did that just so nothing gets in or water doesn't splash out onto the electrically around.
__________________
1976 XB Falcon 500 Wagon - BUILD THREAD Sherwood Green | 3spd/250CI | Running Whitewalls on a 2.5" Drop |
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Washer bottle (2006 Fiesta LX)
Hybrid Mode